I thought I would blog on this. It could be useful for someone who might have an IOS router instead of an ASA and need to create a IPSEC Site-to-Site VPN to a remote peer, then NAT VPN traffic to a different address or subnet if needed, or the local subnets conflict with each other.
Here is a nice little Visio to kind of show what I am going for with the traffic:
Because of duplicate subnets on both sides, I need to nat traffic going to 188.8.131.52 from 192.168.10.10, otherwise traffic should flow normally. How can I achieve conditional nat? By using a route-map and then natting only the traffic in the Route-map. So, lets get our VPN setup first. Remember, we add the NAT network or host IP to our interesting traffic ACL that will be used to define our Phase2
These are my commands:
ip access-list extended VPN-to-Remote permit ip host 10.255.232.10 host 172.20.0.192
crypto map Crypto 6 ipsec-isakmp set peer 184.108.40.206 set transform-set Transform match address VPN-to-Remote
That pretty much gets the VPN up and going. Now for the interesting part – we need to create a new ACL, match my private 192.168.10.10 address and the destination address of the remote server, then match that ACL in my Route-map.
ip access-list extended Nat-for-VPN permit ip host 192.168.10.10 host 172.20.0.192
route-map VPN-to-REMOTE permit 10 match ip address Nat-for-VPN !
Great! So, we now have the route-map created.. so now what? We need to create a NAT statement that references my Route-Map. Then of course with any VPN we need to modify the “NO-NAT” ACL to include the traffic for both the 192.168.10.10, and the 10.255.232.10 to my remote destination.
ip nat inside source static 192.168.10.10 10.255.232.10 route-map VPN-to-HCN extendable
ip access-list extended NO-NAT deny ip host 10.255.232.10 host 172.20.0.192 deny ip host 192.168.10.10 host 172.20.0.192
Now, if we try to access the remote side, does it work? Yes it does, but lets check to see if our nat is really working. It is! As you can see, 192.168.10.10 going to 172.20.0.192 is being natted into 10.255.232.10, but all other traffic gets natted out of the WAN interface.
Lets just check for translations of 10.255.232.10
Bingo, everything works great. Lets make sure that we are getting hits on our Route-Map.